In and out seems a little fuzzier to me, but even then moving the carriage until the drill tracks on center seems pretty quick and easy. Angle seems just as easy, dial indicator and some drill rod to dial it parallel with the ways. So, any first-hand experience floating around out there? How easy is alignment to start drilling? Vertical seems dead simple, set that once and never change it. Id like a way to make drilling deeper holes slightly more tolerable, tailstock only has 1.5 inches of travel and sweet jimney christmas that crank it a bloody pain after a bit. QCTP Tool Holders 3119 Compatible with 2 Morse Taper Shanks Hardened and Ground Compatible with 0XA, or Series 000, Tool Post Number 2 Morse taper.
0 kommentar(er)
